DTC P2610 ECM / PCM Internal Engine Off Timer Performance |
| DTC Code | Monitoring Item | Malfunction Detection Condition | Trouble Area | Detection Timing | Detection Logic |
| P2610 | Soak timer (built into ECM) | ECM internal malfunction | ECM | Engine running | 2 trip |

| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Duration | 10 minutes |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTC not present | None |
| Ignition switch | ON |
| Engine | Running |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Soak timer measurement when ECM CPU clock counts 10 minutes | Less than 7 minutes, or more than 13 minutes |
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream ON.
Clear DTCs (Click here).
Start the engine and wait for 10 minutes or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
If no pending DTC is displayed, the repair has been successfully completed.
| NEXT | ||
| ||