DTC P0560 System Voltage |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0560 | Open in ECM back up power source circuit (1 trip detection logic) |
|
| Related DTCs | P0560: ECM system voltage |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 3 seconds |
| MIL Operation | Immediate (MIL illuminated after next engine start) |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Stand-by RAM | Initialized |
| ECM power source | Less than 3.5 V |

| 1.INSPECT FUSE (EFI NO. 1) |
Remove the EFI NO. 1 fuse from the engine room junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI NO. 1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - EFI NO. 1 FUSE, EFI NO. 1 FUSE - BATTERY) |
![]() |
Check the harness and the connector between the EFI NO. 1 fuse and ECM.
Remove the EFI NO. 1 fuse from the engine room junction block.
Disconnect the A24 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI NO. 1 fuse (2) - A24-1 (BATT) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| EFI NO. 1 fuse (2) or A24-1 (BATT) - Body ground | Always | 10 kΩ or higher |
Check the harness and the connector between the EFI NO. 1 fuse and battery.
Remove the EFI NO. 1 fuse from the engine room junction block.
Disconnect the positive battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Battery positive terminal - EFI NO. 1 fuse (1) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| Battery positive terminal or EFI NO. 1 fuse (1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | |
| 4.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 5.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the Techstream ON.
Clear DTCs (Click here).
Turn the ignition switch OFF and turn the Techstream OFF.
Start the engine and turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0560 | A |
| No output | B |
|
| ||||
| A | ||
| ||