Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC (USING TECHSTREAM)
  1. Turn the ignition switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON and the Techstream on.

  4. Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.

  5. Read the DTCs following the prompts on the Techstream screen.

    HINT:
    Refer to the Techstream operator's manual for further details.


CHECK DTC (USING SST CHECK WIRE)

C156667E01

  1. Turn the ignition switch off.

  2. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

    SST
    09843-18040  

  3. Turn the ignition switch to ON.

  4. Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration above for examples of a normal system code and codes 13 and 33.

    HINT:
    1. If the tire pressure warning light does not output any DTCs or the normal system code, inspect the tire pressure warning light circuit or TC and CG terminal circuit.
      Trouble Area
      See page
      Tire pressure warning light circuit
      Click here
      TC and CG terminal circuit
      Click here
    2. If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is output first.

  5. Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.

  6. After completing the check, turn the ignition switch off and remove SST from the DLC3.

    SST
    09843-18040  


CLEAR DTC

HINT:
After repairing the malfunctions, clear the DTCs.

  1. Turn the ignition switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON and the Techstream on.

  4. Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.

  5. Clear the DTCs following the prompts on the Techstream screen.

    HINT:
    Refer to the Techstream operator's manual for further details.