TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (COMBINATION METER) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and the Techstream on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the condition of the tire pressure warning light by operating the tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Tire Pressure Warning System | Tire Pressure Warning Light illuminates | ON or OFF | - |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECU) |
Disconnect the J31 ECU connector.
Disconnect the J28 meter connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J31-5 (IND) - J28-7 (TIRE) | Always | Below 1 Ω |
| J31-5 (IND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||