TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Reset Switch Circuit |

| 1.CHECK TIRE PRESSURE WARNING RESET SWITCH FUNCTION |
Perform the tire pressure warning reset switch test in Test Mode Procedure (Click here).
| Switch Condition | Specified Condition |
| Tire pressure warning reset switch on | Tire pressure warning light turns on. |
| Tire pressure warning reset switch off | Tire pressure warning light blinks. |
|
| ||||
| OK | ||
| ||
| 2.INSPECT TIRE PRESSURE WARNING RESET SWITCH |
![]() |
Remove the tire pressure warning reset switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | ON (Switch is pressed and held) | Below 1 Ω |
| OFF (Switch is not pressed) | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (RESET SWITCH - ECU AND BODY GROUND) |
Disconnect the J43 reset switch connector.
Disconnect the J31 ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J31-1 (CLSW) - J43-1 | Always | Below 1 Ω |
| J31-1 (CLSW) - Body ground | Always | 10 kΩ or higher |
| J43-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||