FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP OPERATION AND FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check the fuel pump operation.
Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.
Check for fuel leaks.
Check that there are no fuel leaks after performing maintenance anywhere on the system.
If there are fuel leaks, repair or replace parts as necessary.
| 2. CHECK FUEL PRESSURE |
Check that the battery voltage is 11 to 14 V.
Perform the "DISCHARGE FUEL SYSTEM PRESSURE" procedures (Click here).
Disconnect the cable from the negative (-) battery terminal.
![]() |
Remove the fuel pipe clamp from the fuel tube connector.
![]() |
Pinch and pull the fuel tube (fuel tube connector) to disconnect it.
![]() |
Install SST (pressure gauge) as shown in the illustration.
Wipe off any gasoline.
Reconnect the cable to the negative (-) battery terminal.
Operate the fuel pump.
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pressure Switching Valve / High.
Measure the fuel pressure.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pressure Switching Valve / Low.
Measure the fuel pressure.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST and the fuel tube connector to prevent gasoline from spraying.
Reconnect the fuel tube (fuel tube connector).
Check for fuel leaks.
Check that there are no fuel leaks after performing maintenance anywhere on the system.
If there are fuel leaks, repair or replace parts as necessary.
| 3. INSPECT FUEL PRESSURE SWITCHING VALVE OPERATION |
Connect the Techstream to the DLC3.
Start the engine and warm it up.
Turn the Techstream main switch on.
Check the "Short FT" value in the Data List before and after activating the fuel pressure switching valve by performing the Active Test.