FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.
![]() |
Install the fuel suction with pump and gauge tube into the fuel tank.
Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer one complete turn by hand.
![]() |
Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank, as shown in the illustration.
![]() |
Install the 2 fuel tank tubes with the 2 tube joint clips.
![]() |
| 2. INSTALL FUEL TANK ASSEMBLY |
Set the fuel tank on a mission jack and raise the fuel tank.
![]() |
Connect the harness clamp and fuel pump connector to the fuel tank.
Raise the mission jack.
Install the 2 fuel tank bands with the 2 pins and 2 clips.
![]() |
Connect the 2 fuel tank bands with the 2 bolts.
| 3. CONNECT NO. 1 CANISTER OUTLET HOSE |
![]() |
Connect the canister outlet hose to the inlet pipe.
Attach the hose to the No. 1 breather tube clamp.
| 4. CONNECT FUEL TANK TO FILLER PIPE HOSE |
Connect the fuel tank to filler pipe hose to the inlet pipe.
Connect the fuel tank breather tube to the inlet pipe.
Attach the lock claws to the connector by pushing down on the cover, as shown in the illustration.
Attach the filler pipe hose and breather tube to the No. 1 breather tube clamp.
| 5. CONNECT FUEL TANK TO CANISTER TUBE |
![]() |
Connect the vent line hose and install the retainer.
| 6. CONNECT WIRE HARNESS |
![]() |
Attach the harness clamp to the fuel tank.
| 7. CONNECT VENT LINE HOSE |
![]() |
Connect the vent line hose and install the retainer.
| 8. CONNECT FUEL TANK RETURN TUBE |
![]() |
Connect the fuel tank return tube.
Attach the lock claws to the connector by pushing down on the cover, as shown in the illustration.
| 9. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Connect the fuel tank main tube.
Attach the lock claws to the connector by pushing down on the cover, as shown in the illustration.
| 10. INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY (for Rough Road Area Specification Vehicles) |
Install the tank protector with the 2 bolts and 2 nuts.
| 11. INSTALL FUEL TANK CAP |
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 13. INSPECT FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and Techstream main switch ON.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.