FUEL TANK > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the 2 fuel pump ECU connectors.
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.
Crank the engine again, then check that the engine does not start.
Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.
Connect the 2 fuel pump ECU connectors.
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FUEL TANK CAP |
| 4. REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY (for Rough Road Area Specification Vehicles) |
Remove the 2 bolts, 2 nuts and tank protector.
| 5. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Detach the lock claw by lifting up the cover, as shown in the illustration.
Pinch and pull the main tube connector to disconnect the connector from the pipe.
| 6. DISCONNECT FUEL TANK RETURN TUBE |
![]() |
Detach the lock claw by lifting up the cover, as shown in the illustration.
Pinch and pull the return tube connector to disconnect the connector from the pipe.
| 7. DISCONNECT VENT LINE HOSE |
![]() |
Pull up the retainer and disconnect the vent line hose.
| 8. DISCONNECT WIRE HARNESS |
![]() |
Detach the harness clamp from the fuel tank.
| 9. DISCONNECT FUEL TANK TO FILLER PIPE HOSE |
![]() |
Detach the lock claw by lifting up the cover, as shown in the illustration.
Disconnect the fuel tank breather tube from the inlet pipe.
Disconnect the fuel tank to filler pipe hose from the inlet pipe.
Detach the filler pipe hose and breather tube from the No. 1 breather tube clamp.
| 10. DISCONNECT OUTLET NO. 1 CANISTER HOSE |
Disconnect the outlet canister hose from the inlet pipe.
Detach the hose from the No. 1 breather tube clamp.
| 11. REMOVE FUEL TANK ASSEMBLY |
Set a mission jack underneath the fuel tank.
![]() |
Remove the 2 bolts, 2 clips, 2 pins and 2 fuel tank bands.
Slowly lower the mission jack slightly.
![]() |
Detach the wire harness clamp from the fuel tank as shown in the illustration.
Disconnect the fuel pump connector and lower the mission jack.
| 12. REMOVE INLET FUEL TANK PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and inlet pipe.
| 13. REMOVE NO. 1 FUEL TANK HEAT INSULATOR |
![]() |
Remove the nut from the heat insulator.
Using needle-nose pliers, remove the 4 clips shown in the illustration and then remove the heat insulator.
| 14. REMOVE FUEL TANK TO FILLER PIPE HOSE |
![]() |
Remove the filler pipe hose from the fuel tank.
| 15. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
![]() |
Remove the 2 tube joint clips and pull out the 2 fuel tank tubes.
![]() |
Using SST, loosen the retainer.
Remove the retainer.
Remove the fuel suction with pump and gauge tube assembly from the fuel tank.
Remove the gasket from the fuel tank.