Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


C157291
  1. Remove the nut and disconnect the cable.



3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Disconnect the switch connector.



    C155869
  1. Remove the nut, spring washer and transmission control shaft lever RH.



    C155870
  1. Using a screwdriver, bend the tabs of the lock washer.



    C155871
  1. Remove the lock nut and lock washer.



    C155872
  1. Remove the bolt and switch.