NAVIGATION SYSTEM (for Double Cab) > Steering Pad Switch Circuit |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - SPIRAL CABLE) |
![]() |
Disconnect the K21 receiver connector.
Disconnect the J45 cable connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K21-8 (SW2) - J45-5 (AU2) | Always | Below 1 Ω |
| K21-6 (SWG) - J45-4 (EAU) | ||
| K21-7 (SW1) - J45-6 (AU1) | ||
| K21-8 (SW2) - Body ground | Always | 10 kΩ or higher |
| K21-6 (SWG) - Body ground | ||
| K21-7 (SW1) - Body ground |
|
| ||||
| OK | |
| 2.INSPECT SPIRAL CABLE |
![]() |
Disconnect the z3 and J45 cable connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J45-4 (EAU) - z3-8 (EAU) | Spiral cable is turned 2.5 rotations counterclockwise | Below 1 Ω |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise | ||
| J45-5 (AU2) - z3-9 (AU2) | Spiral cable is turned 2.5 rotations counterclockwise | |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise | ||
| J45-6 (AU1) - z3-10 (AU1) | Spiral cable is turned 2.5 rotations counterclockwise | |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise |
|
| ||||
| OK | |
| 3.INSPECT STEERING PAD SWITCH ASSEMBLY |

Disconnect the z3 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 9 (AU2) - 8 (EAU) | No switch is pushed | 100 kΩ or higher |
| MODE switch pushed | Below 1 Ω | |
| On Hook switch pushed | 329 Ω | |
| Off Hook switch pushed | 1000 Ω | |
| Voice switch is pushed | 3110 Ω | |
| 10 (AU1) - 8 (EAU) | No switch is pushed | 100 kΩ or higher |
| Seek+ switch pushed | Below 1 Ω | |
| Seek- switch pushed | 329 Ω | |
| Volume+ switch is pushed | 1000 Ω | |
| Volume- switch is pushed | 3110 Ω |
|
| ||||
| OK | ||
| ||