STEERING PAD SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
w/ Cruise Control:
Using a screwdriver, remove the No. 2 steering wheel cover.
![]() |
w/o Cruise Control:
Using a screwdriver, remove the No. 2 steering wheel cover.
| 3. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Using a screwdriver, remove the steering wheel cover.
| 4. REMOVE STEERING PAD |
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.
Disconnect the 2 connectors and remove the steering pad.
| 5. REMOVE STEERING PAD SWITCH ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 screws.
Detach the 4 pins and remove the steering pad switch.