Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for CrewMax)

AUDIO AND VISUAL SYSTEM (for CrewMax) > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E146480E04


INSPECTION PROCEDURE

1.INSPECT FUSE (RAD NO. 1, ACC)
  1. Disconnect the RAD NO. 1 fuse from the engine room junction block.

  1. Disconnect the ACC fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    RAD NO. 1 fuse
    Always
    Below 1 Ω
    ACC fuse



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (RECEIVER - BATTERY AND BODY GROUND)


    E146481E01
  1. Disconnect the K1*1, K4*2 and K9*2 receiver connectors.

    HINT:
    *1: for Built-in Type Amplifier System
    *2: for Separate Type Amplifier System

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for Built-in Type Amplifier System:
    Tester Connection
    Condition
    Specified Condition
    K1-7 (GND) - Body ground
    Always
    Below 1 Ω
    for Separate Type Amplifier System:
    Tester Connection
    Condition
    Specified Condition
    K4-20 (GND) - Body ground
    Always
    Below 1 Ω
    K9-14 (GND) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    for Built-in Type Amplifier System:
    Tester Connection
    Switch Condition
    Specified Condition
    K1-4 (B) - Body ground
    Always
    11 to 14 V
    K1-3 (ACC) - Body ground
    Ignition switch ACC
    for Separate Type Amplifier System:
    Tester Connection
    Switch Condition
    Specified Condition
    K4-1 (B) - Body ground
    Always
    11 to 14 V
    K9-5 (+B) - Body ground
    K4-11 (ACC) - Body ground
    Ignition switch ACC
    K9-16 (ACC) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)