AUDIO AND VISUAL SYSTEM (for CrewMax) > Stereo Component Amplifier Power Source Circuit |

| 1.INSPECT FUSE (AMP, ACC) |
Disconnect the AMP fuse from the engine room junction block.
Disconnect the ACC fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| AMP fuse | Always | Below 1 Ω |
| ACC fuse |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AMPLIFIER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the K16, K15 and K17 amplifier connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K17-6 (GND) - Body ground | Always | Below 1 Ω |
| K17-7 (GND2) - Body ground |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K16-1 (+B) - K17-6 (GND) | Always | 11 to 14 V |
| K16-5 (+B2) - K17-6 (GND) | ||
| K15-12 (ACC) - K17-6 (GND) | Ignition switch ACC |
|
| ||||
| OK | ||
| ||