Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for Double Cab)

NAVIGATION SYSTEM (for Double Cab) > Illumination for Panel Switch does not Come on with Tail Switch ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)


    E146767E01
  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    TAIL or ON
    ON
    OFF
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A

REPLACE NAVIGATION RECEIVER (Click here)