DTC B2603 Tilt and Telescopic Manual Switch Circuit Malfunction |
| DTC Code | Detection Condition | Trouble Area |
| B2603 | When operating the tilt and telescopic manual switch, abnormal voltage value is input to the multiplex tilt and telescopic ECU. |
|

| 1.READ VALUE USING TECHSTREAM (TILT AND TELESCOPIC MANUAL SWITCH) |
![]() |
Use the Data List to check if the tilt and telescopic manual switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| T&T Manual SW | Voltage data of manual switch/min.: 0 V, max.: 5 V | Neutral position: Below 0.2 V Tilt up: 1.67 to 2.13 V Tilt down: 0.54 to 0.74 V Telescopic contract: 1.08 to 1.40 V Telescopic extend: 2.22 to 2.77 V | - |
| Result | Proceed to |
| Switch voltages in all directions are outside the standard. | A |
| Switch voltages in certain directions are outside the standard. | B |
| Switch voltages in all directions are within the standard. | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - HEADLIGHT DIMMER SWITCH) |

Disconnect the J47 multiplex tilt and telescopic ECU connector.
Disconnect the J10 headlight dimmer switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J47-4 (VC) - J10-8 (VC) | Always | Below 1 Ω |
| J47-3 (MSW) - J10-10 (MSW) | Always | Below 1 Ω |
| J10-8 (VC) - Body ground | Always | 10 kΩ or higher |
| J10-10 (MSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK MULTIPLEX TILT AND TELESCOPIC ECU (VC TERMINAL VOLTAGE) |
![]() |
Reconnect the J47 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J47-4 (VC) - J47-3 (MSW) | Ignition switch ON | 4.9 to 5.1 V |
|
| ||||
| OK | |
| 4.INSPECT HEADLIGHT DIMMER SWITCH (TILT AND TELESCOPIC MANUAL SWITCH) |
![]() |
Disconnect the J10 headlight dimmer switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (VC) - 10 (MSW) | Tilt up | 342 to 378 Ω |
| Tilt down | 1890.5 to 2089.5 Ω | |
| Telescopic contract | 750.5 to 829.5 Ω | |
| Telescopic extend | 152 to 168 Ω |
|
| ||||
| OK | ||
| ||