Home › STEERING › STEERING COLUMN › MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column)

MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE UPPER STEERING COLUMN COVER


C160535
  1. Remove the 2 screws.

    HINT:
    Turn the steering wheel to the right and left as necessary to remove the 2 screws.



    C162097
  1. Detach the 4 clips.

  1. Detach the claw to remove the upper steering column cover.



3. REMOVE LOWER STEERING COLUMN COVER


C160536
  1. Detach the 2 claws to remove the lower steering column cover.



4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B166023
  1. Detach the 2 claws.

  1. Disconnect the hood lock control cable and remove the hood lock lever.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B160582
  1. Remove the hood lock control lever.

  1. Remove the 2 bolts.

  1. Detach the 4 clips and claw.



    B163883
  1. for Automatic Air Conditioning System:
    Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



6. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT


    B160602
  1. Remove the 4 bolts.

  1. Detach the 2 claws.

  1. Remove the safety pad and then disconnect the connector.



7. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY


C154523
  1. Remove the bolt and air duct.



8. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU


C162089
  1. Disconnect the 2 ECU connectors.

  1. Remove the 2 screws and ECU.