Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


D027914E04
  1. Install the spring and check ball body.



    C157293E01
  1. Insert the pin of the manual valve into the hole of the manual valve lever.



    C157292E01
  1. Install the 19 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.

    36 mm (1.42 in.) for bolt A
    25 mm (0.984 in.) for bolt B

  1. Install the detent spring cover and detent spring with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. CONNECT TRANSMISSION WIRE


    C125285E02
  1. Connect the 7 connectors to the solenoid valves.

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    Torque:
    for bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    for bolt B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A

    36 mm (1.41 in.) for bolt B



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


D028692E01
  1. Coat a new O-ring with ATF and install it to the oil strainer.

  1. Install the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


C153314E01

NOTICE:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



6. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).