Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TELEVISION CAMERA ASSEMBLY

E177910E01

  1. Disconnect the X1 camera connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    X1-4 (CGND) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    X1-3 (CB+) - X1-4 (CGND)
    B - W
    Power source
    Ignition switch ON, shift lever R position
    5.5 to 7.05 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the X1 camera connector.

  4. Measure the waveform according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    X1-1 (CV+) - X1-2 (CV-)
    R - L
    Display signal
    Ignition switch ON, shift lever R position
    Waveform
    If the result is not as specified, the camera may have a malfunction.



  5. E119731E01
  6. Using an oscilloscope, check the waveform.
    Waveform (Reference) 
    Item
    Content
    Terminal No. (Symbols)
    X1-1 (CV+) - X1-2 (CV-)
    Tool Setting
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch ON, shift lever R position


CHECK NAVIGATION RECEIVER ASSEMBLY (Click here)