Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for CrewMax)

AUDIO AND VISUAL SYSTEM (for CrewMax) > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

The radio receiver sends a sound signal to the stereo component amplifier through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier or speakers.

WIRING DIAGRAM


E140460E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    E145923E01
  1. Disconnect the K4 receiver connector.

  1. Disconnect the K15 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K4-9 (L+) - K15-3 (L+)
    Always
    Below 1 Ω
    K4-19 (L-) - K15-2 (L-)
    K4-8 (R+) - K15-5 (R+)
    K4-18 (R-) - K15-4 (R-)
    K4-10 (SLD) - K15-6 (SLD)
    K4-9 (L+) - Body ground
    Always
    10 kΩ or higher
    K4-19 (L-) - Body ground
    K4-8 (R+) - Body ground
    K4-18 (R-) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)