Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CELLULAR PHONE
  1. Check if the other side can hear your voice properly.

    OK:
    Your voice can be heard correctly.



NG
REPLACE CELLULAR PHONE
OK


2.CHECK SETTINGS


    E147700E02
  1. Check if the mute switch is set to ON.

    OK:
    Mute switch is not set to ON.



NG
TURN MUTE SWITCH OFF
OK


3.CHECK SETTINGS


    E147701E02
  1. Enter the "Handsfree Voice Quality Set" mode (Click here).

  1. Check if the Send Voice Level is set to "0".

    HINT:
    The Send Voice Level can be set to 11 different levels, -5 to +5, with a 3 dB difference.

  1. Check if the Send Voice Level is set to the minimum or maximum level.

    HINT:
    When the Send Voice Level is set to the minimum or maximum level, the sound may be distorted.

    OK:
    The Send Voice Level is set to "0".



NG
SET SEND VOICE LEVEL TO "0"
OK


4.CHECK MICROPHONE (NAVIGATION CHECK MODE)


    E125118E03
  1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When a voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    The recording limit is 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
A

REPLACE NAVIGATION RECEIVER (Click here)