Home › DRIVE LINE › DRIVE SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 4WD)

FRONT DRIVE SHAFT ASSEMBLY (for 4WD) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 5 bolts, 3 screws and engine under cover.



3. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. for Front Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 398 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and drain the oil.

    3. Install a new gasket and the drain plug.

      Torque:
      49 N*m{ 500 kgf*cm , 36 ft.*lbf }



4. DISCONNECT FRONT SPEED SENSOR LH
  1. Disconnect the front speed sensor LH (Click here).



5. REMOVE FRONT AXLE HUB GREASE CAP


    C159317
  1. Using a screwdriver and hammer, remove the axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



6. REMOVE AXLE HUB NUT


    C159318
  1. Remove the cotter pin and adjusting lock cap.

  1. Using a 39 mm socket wrench, remove the axle hub nut.



7. REMOVE TIE ROD END SUB-ASSEMBLY


C154516E01
  1. Put matchmarks on the tie rod end LH and steering rack end.



8. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH


C155985
  1. Remove the 2 bolts and disconnect the attachment from the steering knuckle.



9. DISCONNECT FRONT DRIVE SHAFT ASSEMBLY LH
  1. Using plastic-faced hammer, disconnect the drive shaft from the axle hub side.

  1. Push the steering knuckle outward and disconnect the drive shaft from the steering knuckle.



10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


    C159289E01
  1. Using SST, remove the drive shaft.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Be careful not to damage the dust cover and oil seal.

  1. Using a screwdriver, remove the snap ring from the inboard joint shaft.