Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR

FRONT SPEED SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT WHEEL


3. REMOVE FRONT SKID CONTROL SENSOR WIRE LH


    C154445E01
  1. Disconnect the connector (labeled A) from the front speed sensor.

  1. Detach the 3 clips (labeled B) and remove the clamp bolt (labeled C).



    C154447E01
  1. Disconnect the connector (labeled D).

  1. Remove the 3 bolts (labeled E), 3 harness clamps (labeled F) and sensor wire.



4. REMOVE FRONT SPEED SENSOR LH


C155492E01
  1. Remove the hexagon socket head cap bolt (labeled A) and speed sensor (labeled B) from the knuckle.



5. REMOVE FRONT SKID CONTROL SENSOR CLAMP LH
  1. Remove the bolt (labeled C) and skid control sensor clamp (labeled D) from the knuckle.



6. REMOVE FRONT SKID CONTROL SENSOR WIRE RH


    C154444E01
  1. Disconnect the connector (labeled A) from the front speed sensor.

  1. Detach the 3 clips (labeled B) and remove the clamp bolt (labeled C).



    C154446E01
  1. Disconnect the connector (labeled D).

  1. Remove the connector (labeled D) from the skid control sensor clamp (labeled H).

  1. Remove the 2 bolts (labeled E) and 2 harness clamps (labeled F).

  1. Remove the bolt (labeled G) and skid control sensor clamp (labeled H).



7. REMOVE FRONT SPEED SENSOR RH


    C155493E01
  1. Remove the hexagon socket head cap bolt (labeled A) and speed sensor (labeled B) from the knuckle.



8. REMOVE FRONT SKID CONTROL SENSOR CLAMP RH
  1. Remove the bolt (labeled C) and skid control sensor clamp (labeled D) from the knuckle.