STEERING KNUCKLE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH |
Remove the front axle hub (Click here).
| 3. DISCONNECT FRONT SPEED SENSOR LH |
![]() |
Remove the clip and bolt.
Disconnect the speed sensor from the steering knuckle.
| 4. DISCONNECT TIE ROD END SUB-ASSEMBLY LH |
Remove the cotter pin and nut.
![]() |
Using SST, disconnect the tie rod end LH from the steering knuckle.
| 5. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH |
![]() |
Remove the 2 bolts and disconnect the attachment from the steering knuckle.
| 6. REMOVE STEERING KNUCKLE LH |
Support the front suspension lower arm LH with a jack.
Remove the clip and the nut.
![]() |
Using SST, disconnect the upper ball joint from the steering knuckle.
Remove the steering knuckle.
| 7. REMOVE KNUCKLE GREASE RETAINER CAP LH (for 2WD) |
![]() |
Using a screwdriver and hammer, tap out the retainer cap.
| 8. REMOVE STEERING KNUCKLE OIL SEAL LH (for 4WD) |
![]() |
Using a screwdriver and hammer, tap out the oil seal.