Home › DRIVE LINE › DIFFERENTIAL › DIFFERENTIAL CARRIER ASSEMBLY (for 3UR-FE, 3UR-FBE)

DIFFERENTIAL CARRIER ASSEMBLY (for 3UR-FE, 3UR-FBE) > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE PROPELLER SHAFT ASSEMBLY
  1. Remove the propeller shaft for 2WD (Click here).

  1. Remove the propeller shaft for 4WD (Click here).



3. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. for Front Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 398 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and drain the oil.

    3. Install a new gasket and the drain plug.

      Torque:
      49 N*m{ 500 kgf*cm , 36 ft.*lbf }



4. REMOVE REAR AXLE SHAFT LH
  1. Remove the rear axle shaft LH (Click here).



5. REMOVE REAR AXLE SHAFT RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY


    C159767
  1. Remove the 10 nuts, 10 washers and differential carrier.

    NOTICE:
    Be careful not to damage the contact surfaces of the differential carrier and rear axle housing.

  1. Remove the gasket.