Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE REAR WHEEL LH


3. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



4. DISCONNECT REAR BRAKE FLEXIBLE HOSE


    C154490E05
  1. Disconnect the brake tube from the flexible hose with union nut wrench while holding the flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  1. Remove the clip.



5. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    C158344
  1. Remove the 2 bolts and disconnect rear disc brake cylinder.

    NOTICE:
    1. Do not twist or bend the flexible hose.
    2. Do not disconnect the flexible hose from the disc brake cylinder.



6. REMOVE REAR DISC LH


    C155452E01
  1. Put matchmarks on the rear disc and axle hub if planning to reuse the disc.



    C155453
  1. Turn the shoe adjuster until the disc turns freely, and then remove the disc.



7. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING LH


    C179358E01
  1. Using SST, remove the return spring.

    SST
    09703-30011  



8. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    C155124E01
  1. Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

    SST
    09718-00011  

  1. Disconnect the tension spring.

  1. Remove the No. 1 parking brake shoe and shoe adjuster screw set.



9. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    C154249E01
  1. Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

    SST
    09718-00011  

  1. Remove the No. 2 parking brake shoe.



10. REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH


    C155125
  1. Disconnect the No. 3 parking brake cable from the parking brake shoe lever.

  1. Remove the parking brake shoe lever.



11. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C154244
  1. Disconnect the bolt and No. 3 parking brake cable.



12. DISCONNECT REAR SPEED SENSOR LH


    C154449E02
  1. Disconnect the speed sensor connector (labeled A).

  1. Remove the nut (labeled B) and speed sensor (labeled C).



13. REMOVE REAR AXLE SHAFT


    C159453
  1. Remove the 4 nuts and rear axle shaft together with the parking brake plate.

  1. Remove the O-ring.



14. REMOVE REAR AXLE SHAFT OIL SEAL


    C159454E01
  1. Using SST, tap out the oil seal.

    SST
    09308-00010  

    NOTICE:
    Be careful not to damage the axle housing hole.