Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for Double Cab)

DTC    58-10    Gyro Error

DTC    80-10    Gyro Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
58-10
Ground short, power supply short, or open circuit in gyro signal.
  1. Gyro sensor
  2. Navigation receiver
80-10

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs (Click here).

1.CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)


    E120088
  1. Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. Check the gyro voltage.

    Standard voltage:
    0.5 to 4.5 V

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK DTC
  1. Recheck for DTCs and check if the same trouble occurs again.

    HINT:
    If DTCs are detected frequently, replace the navigation receiver.

    OK:
    Malfunction disappears.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A

END