Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for Double Cab)

DTC    58-43    SPD Signal Error

DTC    80-43    SPD Signal Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
58-43
Difference between GPS speed and SPD pulse is detected.
  1. Speed signal circuit
  2. Navigation receiver
80-43

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs (Click here).

1.CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)


    E120089
  1. Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
GO TO "SPEED SIGNAL DOES NOT CHANGE IN THE NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
A

REPLACE NAVIGATION RECEIVER (Click here)