Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR

REAR SPEED SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE REAR WHEEL


3. REMOVE REAR SPEED SENSOR LH


    C154449E02
  1. Disconnect the speed sensor connector (labeled A).

  1. Remove the nut (labeled B) and speed sensor (labeled C).



4. REMOVE REAR SPEED SENSOR RH


    C154450E01
  1. Disconnect the speed sensor connector (labeled A).

  1. Remove the nut (labeled B) and speed sensor (labeled C).



5. REMOVE SKID CONTROL SENSOR WIRE
  1. Disconnect the sensor connector (labeled A).

  1. Detach the 7 clips (labeled B).

  1. Remove the bolt (labeled C).



  1. Remove the nut (labeled D) and skid control sensor wire.


    C154448E01