Home › TRANSMISSION ยท AB60F AUTOMATIC TRANSMISSION › OIL COOLER (w/ Trailer Towing System)

OIL COOLER (w/ Trailer Towing System) > INSTALLATION

for Preparation Click here



1. INSTALL OIL COOLER ASSEMBLY


C155881
  1. Install the No. 1 and No. 2 oil cooler air ducts with the 4 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the oil cooler support with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    C155880E01
  1. Temporarily put the oil cooler on the radiator support.

    NOTICE:
    Securely attach the claw of the oil cooler into the hole of the radiator support.

  1. Install the 3 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



2. INSTALL OIL COOLER TUBE


C161349
  1. Install the oil cooler tube with the 2 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



3. CONNECT TRANSMISSION OIL COOLER HOSE


C161350E01
  1. Connect the inlet No. 1 oil cooler hose and outlet No. 1 oil cooler hose as shown in the illustration.

    NOTICE:
    Make sure the pinching portion of each clip is facing the direction shown in the illustration.

  1. Pass the 2 hoses through the flexible hose clamp and close the clamp as shown in the illustration.



    C161351E01
  1. Connect the inlet No. 2 transmission oil cooler hose and outlet No. 2 transmission oil cooler hose.

    NOTICE:
    1. Make sure the pinching portion of each clip is facing the direction shown in the illustration.
    2. Make sure the paint portion of each hose is facing outward.

  1. Install the bolt to fix the water by-pass pipe in place.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



4. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).



5. INSTALL FRONT BUMPER ASSEMBLY
  1. for Steel Type:
    Install the front bumper (Click here).

  1. for Resin Type:
    Install the front bumper (Click here).