FRONT BUMPER (for Steel Type Bumper) > INSTALLATION |
| 1. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH |
![]() |
Install the bumper extension with the 4 nuts.
| 2. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH |
| 3. INSTALL FRONT BUMPER REINFORCEMENT |
Install the reinforcement with the 6 nuts.

| 4. INSTALL FRONT BUMPER ARM LH |
![]() |
Install the bumper arm with the 3 nuts.
| 5. INSTALL FRONT BUMPER ARM RH |
| 6. INSTALL FRONT BUMPER END RETAINER LH |
![]() |
Install the retainer with the 3 nuts.
| 7. INSTALL FRONT BUMPER END RETAINER RH |
| 8. INSTALL FRONT UPPER CENTER BUMPER RETAINER |
Install the retainer with the 6 nuts.

| 9. INSTALL FRONT BUMPER SIDE SUPPORT LH |
![]() |
Attach the 3 claws to install the side support.
Install the 2 screws.
| 10. INSTALL FRONT BUMPER SIDE SUPPORT RH |
| 11. INSTALL FRONT BUMPER BAR |
w/o Fog Light:
Install the front bumper bar.
w/ Intuitive Parking Assist System:
Connect the ultrasonic sensor connectors.
Install the bumper bar with the 8 bolts and 7 screws.

![]() |
Install 2 new clips.
w/ Fog Light:
Install the front bumper bar.
w/ Intuitive Parking Assist System:
Connect the ultrasonic sensor connectors.
Install the bumper bar with the 8 bolts and 3 screws.

| 12. INSTALL FRONT BUMPER COVER SUB-ASSEMBLY |
Attach the 4 claws and 2 pins to install the bumper cover.

![]() |
Install the screw and clip.
Install the 16 bolts and 8 clips.

| 13. INSTALL FRONT END PANEL LH |
![]() |
Attach the 2 pins to install the panel.
Install the 2 clips.
| 14. INSTALL FRONT END PANEL RH |
| 15. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (w/ Fog Light) |
Connect the fog light connector.
![]() |
Install the clip.
![]() |
Install the front fender splash shield with the 2 screws, clip and 2 new clips labeled A.
| 16. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Fog Light) |
| 17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |