Home › BRAKE › PARKING BRAKE › PARKING BRAKE PEDAL

PARKING BRAKE PEDAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. RELEASE PARKING BRAKE PEDAL


3. REMOVE INSTRUMENT SIDE PANEL LH


    B160581
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B160582
  1. Remove the hood lock control lever.

  1. Remove the 2 bolts.

  1. Detach the 4 clips and claw.



    B163883
  1. for Automatic Air Conditioning System:
    Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT


    B160602
  1. Remove the 4 bolts.

  1. Detach the 2 claws.

  1. Remove the safety pad and then disconnect the connector.



6. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    C154230
  1. Remove the lock nut and adjustment nut.



    C154232
  1. Remove the clip.



    C155437
  1. Using a screwdriver, slowly bend up the claw.

    NOTICE:
    Be careful not to damage the No. 1 parking brake cable or claw.

  1. Disconnect the parking brake cable from the parking brake control pedal.



7. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    C154233
  1. Disconnect the connector.

  1. Detach the wire harness clamp from the control pedal.



    C154234
  1. Remove the 3 nuts and parking brake control pedal from the body.