Home › BRAKE › BRAKE › BRAKE BOOSTER

BRAKE BOOSTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. Remove the brake master cylinder (Click here).



4. DISCONNECT VACUUM HOSE ASSEMBLY
  1. Slide the clip and disconnect the vacuum hose from the check valve.



5. DISCONNECT BRAKE BOOSTER CONNECTOR
  1. Disconnect the 2 brake booster connectors from the brake booster.



6. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)


B165843
  1. Detach the 6 claws and 3 clips, and remove the scuff plate.



7. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)


B165841
  1. Detach the 6 claws and 3 clips, and remove the scuff plate.



8. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B160582
  1. Remove the hood lock control lever.

  1. Remove the 2 bolts.

  1. Detach the 4 clips and claw.



    B163883
  1. for Automatic Air Conditioning System:
    Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



10. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT


    B160602
  1. Remove the 4 bolts.

  1. Detach the 2 claws.

  1. Remove the safety pad and then disconnect the connector.



11. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin.



12. REMOVE BRAKE BOOSTER ASSEMBLY


    C154474
  1. Remove the 4 nuts, and then pull out the brake booster.

  1. Remove the gasket from the brake booster.

  1. Loosen the lock nut and then remove the clevis.



13. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY