SHIFT LEVER ASSEMBLY (for Column Shift Type) > INSTALLATION |
| 1. INSTALL COLUMN SHIFT ASSEMBLY |
![]() |
Using a T30 ''TORX'' wrench, install the column shift with the 3 bolts.
Connect the connector and attach the harness clamp.
![]() |
Connect the column shift transmission control cable end to the column shift.
| 2. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Install the turn signal switch with spiral cable to the steering column with the clamp.
![]() |
Connect the 5 connectors to the turn signal switch with spiral cable.
| 3. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 4. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 5. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel set nut.
| 6. INSTALL STEERING PAD (w/ Steering Pad Switch) |
![]() |
Support the steering pad with one hand.
Connect the 2 connectors to the steering pad.
Confirm that the circumference groove of the screw fits in the screw case, and place the steering pad onto the steering wheel .
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 7. INSTALL STEERING PAD (w/o Steering Pad Switch) |
![]() |
Support the steering pad with one hand.
Connect the 2 connectors to the steering pad.
Confirm that the circumference groove of the screw fits in the screw case, and place the steering pad onto the steering wheel .
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 8. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT |
![]() |
Connect the connector.
Attach the 2 claws to install the safety pad.
Install the 4 bolts.
| 9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Connect the connector.
Attach the 2 claws to install the safety pad.
Install the 4 bolts.
| 10. INSTALL COWL SIDE TRIM BOARD LH |
![]() |
Attach the 2 clips to install the cowl side trim board.
Install the clip.
| 11. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax) |
![]() |
Attach the 6 claws and 3 clips to install the scuff plate.
| 12. INSTALL FRONT DOOR SCUFF PLATE LH (for Regular Cab) |
![]() |
Attach the 6 claws and 3 clips to install the scuff plate.
| 13. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
![]() |
Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press the lock piece from the back side to release the lock.
![]() |
Check that the adjust case's spring is applying enough tension to the shift control cable. Then press the lock piece to set the lock.
Return the cover of the adjust case to its original position.
Inspect the operation after the adjustment.
| 14. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from the N position to other positions, check that the lever can be shifted smoothly and accurately to each position and that the position indicator comes on in accordance with the shift lever position.
If the indicator and shift lever position do not match, carry out the following adjustment procedures.
| 15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |