Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    U0101    Lost Communication with TCM

for Preparation Click here


DESCRIPTION

The Transmission Control Module (TCM) and ECM perform 2-way communications with each other via the Controller Area Network (CAN). The TCM sends signals to the ECM concerning required engine rpm, required engine torques, warning indicators in the combination meter, DTCs and other data. The ECM sends signals to the TCM concerning engine rpm, opening angles of the throttle valve, temperature of intake air, temperature of engine coolant, engine torques and other data. If the TCM cannot communicate with the ECM, the TCM will conclude that there is a malfunction in the CAN system, illuminate the MIL and set a DTC.

DTC Code
DTC Detection Condition
Trouble Area
U0101
No communication from TCM continues
  1. Open or short in TCM and ECM circuit
  2. TCM
  3. ECM

MONITOR STRATEGY


Related DTCs
U0101: Verify communication
Required Sensors/Components (Main)
ECM
Required Sensors/Components (Related)
-
Frequency of Operation
Continuous
Duration
1.25 seconds
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs are not present
None
Battery voltage
10.5 V or higher
Ignition switch
ON
Starter
OFF

TYPICAL MALFUNCTION THRESHOLDS


Communication signal
Lost communication with TCM

INSPECTION PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0101)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.
    Result 
    Result
    Proceed to
    U0101 is output
    A
    U0101 and other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A


2.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


3.CHECK IF DTC RECURS
  1. Connect the Techstream to the DLC3.

  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Read the DTCs.
    Result 
    Result
    Proceed to
    No DTC is output
    A
    Other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A

END