ECM > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DISCONNECT CONNECTOR HOLDER BLOCK |
![]() |
Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.
| 3. REMOVE ECM |
![]() |
Raise the 2 levers while pushing the locks on the 2 levers.
![]() |
Disconnect the 2 connectors.
![]() |
Remove the 4 bolts and ECM.
| 4. REMOVE ECM GASKET |
![]() |
Peel off the rubber part of the gasket.
![]() |
Spray gasket remover or equivalent on the remaining tape of the gasket.
![]() |
Use a cutter knife to remove the tape of the gasket.