Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE LICENSE PLATE LIGHT ASSEMBLY LH (for Resin Type Bumper)


B166101
  1. Remove the screw.

  1. Detach the claw and remove the license plate light.



3. REMOVE LICENSE PLATE LIGHT ASSEMBLY LH


B166101
  1. Remove the screw.

  1. Detach the claw and remove the license plate light.



4. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH (for Resin Type Bumper)

HINT:
Use the same procedures described for the LH side.



5. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE REAR BUMPER PAD SUB-ASSEMBLY LH
  1. Remove the clip.



  1. Detach the 14 clips and remove the rear bumper pad.

    HINT:
    Detach the clips from the backside of the rear bumper.



    B166111



7. REMOVE REAR BUMPER PLATE LH


B166112
  1. Detach the 4 clips and remove the rear bumper plate.

    HINT:
    Detach the clips from the backside of the rear bumper.



8. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedures described for the LH side.



9. REMOVE REAR BUMPER COVER (for Resin Type Bumper)


  1. w/ Intuitive Parking Assist System:
    Disconnect the connectors and clamps shown in illustration.


    B166117

  1. Remove the 2 clips and 4 screws.

  1. Remove the 4 bolts and 2 nuts.



  1. Detach the 4 claws and remove the rear bumper cover.


    B166102



10. REMOVE REAR BUMPER BAR


  1. w/ Intuitive Parking Assist System:
    Disconnect the connectors and clamps shown in the illustration.


    B166116

  1. Remove the 4 bolts and 2 bumper bar reinforcements.



  1. Remove the 6 bolts and bumper bar.


    B166113E01



11. REMOVE NO. 1 ULTRASONIC SENSOR


    E146470
  1. While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.



12. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E146469
  1. Detach the 2 claws and remove the sensor retainer from the rear bumper.



13. REMOVE NO. 2 ULTRASONIC SENSOR


    E146468
  1. While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.



14. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER


    E146469
  1. Detach the 2 claws and remove the sensor retainer from the rear bumper.