Home › STEERING › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. The power tilt and power telescopic steering column system uses the CAN communication system, so check its diagnostic system before proceeding to troubleshooting.
  3. If the problem still occurs when there is no abnormality in the related circuits, check the multiplex tilt and telescopic ECU and replace it if necessary.


Power tilt and power telescopic steering column system 
Symptom
Suspected Area
See page
Tilt and telescopic function does not operate at all
Check DTCs
Click here
Actuator power source circuit
Click here
IG power source circuit
Click here
Manual switch only does not operate
Tilt and telescopic manual switch circuit
Click here
Headlight dimmer switch assembly (tilt and telescopic manual switch)
Click here
Auto away/return function only does not operate
Check status of auto away function using the Techstream
Click here
IG power source circuit
Click here
Actuator power source circuit
Click here
Auto away function only does not operate
Unlock warning switch
Click here
Ignition switch
Click here
Multiplex tilt and telescopic ECU
Click here
Auto return function only does not operate
Unlock warning switch
Click here
Ignition switch
Click here
Multiplex tilt and telescopic ECU
Click here
Memory function only does not operate
Front power seat control ECU and switch LH
Click here
Multiplex tilt and telescopic ECU
Click here