DTC 5C-40 Camera Picture Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 5C-40 | Synchronous signal from camera cannot be transmitted. |
|

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION CAMERA) |
![]() |
Disconnect the K7 receiver connector.
Disconnect the X1 camera connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| X1-3 (CB+) - K7-24 (CA+) | Always | Below 1 Ω |
| X1-4 (CGND) - K7-21 (CGND) | ||
| X1-1 (CV+) - K7-22 (V+) | ||
| X1-2 (CV-) - K7-23 (V-) | ||
| X1-3 (CB+) - Body ground | Always | 10 kΩ or higher |
| X1-4 (CGND) - Body ground | ||
| X1-1 (CV+) - Body ground | ||
| X1-2 (CV-) - Body ground |
|
| ||||
| OK | |
| 2.CHECK NAVIGATION RECEIVER (CA+ VOLTAGE) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K7-24 (CA+) - K7-21 (CGND) | Ignition switch ON, shift lever in R position | 5.5 to 7.05 V |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | ||
| ||