WIRELESS DOOR LOCK CONTROL SYSTEM > No Answer-Back |

| 1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION |
Check the wireless door lock control functions by operating the transmitter switch.
| Result | Proceed to |
| Wireless door lock functions are normal but hazard warning light answer-back does not occur | A |
| Wireless door lock functions are normal but wireless door lock buzzer answer-back does not occur | B |
| Doors cannot be locked and unlocked with transmitter | C |
|
| ||||
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (TURN SIGNAL FLASHER RELAY) |
Select the Active Test, use the Techstream to generate a control command, and then check that the hazard warning lights flash.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Hazard | Flasher relay | ON or OFF | - |
|
| ||||
| OK | ||
| ||
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (WIRELESS DOOR LOCK BUZZER) |
Select the Active Test, use the Techstream to generate a control command, and then check that the wireless buzzer operates normally.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Wireless Buzzer | Sounds wireless buzzer | ON or OFF | - |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (WIRELESS DOOR LOCK BUZZER - MAIN BODY ECU AND BODY GROUND) |
![]() |
Disconnect the A34 buzzer connector.
Disconnect the J1 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A34-1 - J1-7 (BZR) | Always | Below 1 Ω |
| A34-2 - Body ground | ||
| A34-1 or J1-7 (BZR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK WIRELESS DOOR LOCK BUZZER (OPERATION) |
Temporarily replace the wireless door lock buzzer with a new or normally functioning one (Click here).
Check that the buzzer sounds when using the transmitter LOCK and UNLOCK switches.
|
| ||||
| OK | ||
| ||