Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for CrewMax)

AUDIO AND VISUAL SYSTEM (for CrewMax) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter sends an external device sound signal to the radio receiver through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier or radio receiver, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver, or speakers.

WIRING DIAGRAM


E146453E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER)


    E145924E01
  1. Disconnect the K3 receiver connector.

  1. Disconnect the J7 adapter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K3-17 (ALI) - J7-1 (ALO)
    Always
    Below 1 Ω
    K3-15 (ARI) - J7-2 (ARO)
    K3-16 (ASGN) - J7-3 (ASGN)
    K3-18 (AUXG) - J7-5 (AUXG)
    K3-19 (AUXI) - J7-4 (AUXO)
    K3-17 (ALI) - Body ground
    Always
    10 kΩ or higher
    K3-15 (ARI) - Body ground
    K3-16 (ASGN) - Body ground
    K3-19 (AUXI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)