Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1300/62    Skid Control ECU Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU outputs this DTC if malfunctions are found in the circuit inside the ECU by self-diagnosis.

DTC Code
DTC Detection Condition
Trouble Area
C1300/62
Malfunction in skid control ECU
VSC actuator assembly (skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Turn the ignition switch to ON.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)