Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > Radio Broadcast cannot be Received or Poor Reception

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER
  1. Check the radio's automatic station search function.

    1. Check the radio's automatic station search function by activating it.

      OK:
      The radio's automatic station search function works properly.

      Result 
      Result
      Proceed to
      OK (for Column Shift Type)
      A
      OK (for Floor Shift Type)
      B
      NG
      C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
Go to step 2
A

REPLACE NAVIGATION RECEIVER (Click here)  

2.CHECK OPTIONAL COMPONENTS
  1. Check optional components (sun-shade film, telephone antenna, etc.).

    1. Check if any optional components, such as a sunshade film or telephone antenna that may decrease reception capacity, are installed.

      OK:
      Optional components are installed.

      NOTICE:
      Do not remove any optional components installed by the customer without his or her consent.



NG
Go to step 3
OK

REMOVE AND RECHECK OPTIONAL COMPONENTS (SEE NOTICE ABOVE) 

3.CHECK NAVIGATION RECEIVER


    E050367E01
  1. Preparation for check

    1. Remove the antenna plug from the navigation receiver.

  1. Check for noise

    1. Turn the ignition switch ACC with the navigation receiver connector connected.

    2. Turn the radio on and enter AM mode.

    3. Place a screwdriver, thin wire, or other metal object on the navigation receiver's antenna jack and check that noise can be heard from the speaker.

      OK:
      Noise occurs.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


4.REPLACE POLE ANTENNA
  1. Replace the antenna (Click here) and check that it operates normally.

    OK:
    The antenna operates normally.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END