THROTTLE BODY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.
Remove the radiator cap. Then drain the coolant.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 3. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and throttle body cover.
| 4. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose and No. 2 ventilation hose.
Loosen the 2 hose clamps.
Remove the air cleaner hose.
| 5. REMOVE THROTTLE BODY ASSEMBLY |
![]() |
Disconnect the 2 water by-pass hoses.
![]() |
Disconnect the throttle position sensor and control motor connector.
Remove the 3 bolts, nut, throttle body and gasket.