Home › ENGINE · 2UZ-FE › ENGINE CONTROL SYSTEM › CIRCUIT OPENING RELAY

CIRCUIT OPENING RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE CIRCUIT OPENING RELAY (C/OPN)
  1. Remove the engine room relay block cover.

  1. Remove the circuit opening relay from the engine room relay block.



3. INSPECT CIRCUIT OPENING RELAY (C/OPN)


B060778E14
  1. Measure the resistance according to the the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



4. INSTALL CIRCUIT OPENING RELAY (C/OPN)


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).