Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › VVT SENSOR

VVT SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 5 bolts, 3 screws and engine under cover.



3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    A151786E01

  1. Tighten the radiator drain cock plug by hand.



4. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
  1. Remove the front wiper motor and link assembly (Click here).



5. REMOVE FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY
  1. Disconnect the 2 washer hoses.



  1. Remove the 7 bolts and front cowl top outer panel.


    A151796



6. REMOVE V-BANK COVER


    A112983E03
  1. Remove the 2 nuts and V-bank cover.



7. REMOVE NO. 2 AIR CLEANER HOSE


A151771
  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner hose.



8. REMOVE AIR CLEANER ASSEMBLY WITH ELEMENT


    A151812
  1. Disconnect the No. 2 ventilation hose.

  1. Detach the hose clamp.



    A151769
  1. Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Using a clip remover, detach the 2 wire harness clamps.



    A151770
  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner with element.



9. REMOVE VVT SENSOR (for Bank 1)


    G038105
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



10. REMOVE VVT SENSOR (for Bank 2)


    A076414
  1. Disconnect the No. 4 and No. 5 water by-pass hoses.

  1. Disconnect the sensor connector.



    G038106
  1. Remove the bolt and sensor.