Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring of the sensor.



    A076417
  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



2. CONNECT COOLER COMPRESSOR ASSEMBLY


    A158632E01
  1. Install the cooler compressor with the 2 nuts and 2 bolts in several steps in the sequence shown in the illustration.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }

  1. Connect the cooler compressor connector.



3. INSTALL GENERATOR ASSEMBLY


    A152257
  1. Install the generator with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



    A152256
  1. Install the wire harness clamp bracket with the bolt.

    Torque:
    8.2 N*m{ 84 kgf*cm , 73 in.*lbf }

  1. Install the wire harness clamp to the bracket.

  1. Connect the generator wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Install the terminal cap.

  1. Connect the generator connector.



    A152255
  1. Install the wire harness clamp bracket with the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



4. INSTALL FAN AND GENERATOR V BELT


    A076442E02
  1. While turning the belt tensioner counterclockwise, align the holes, and then insert a bar of φ 6 mm (0.236 in.) into the holes to fix the belt tensioner.



  1. Install the fan and generator V belt.

    HINT:
    A151277E01
    If it is hard to install the fan and generator V belt, perform the following procedures.
    1. Put the fan and generator V belt on all parts except the vane pump, as shown in the illustration.
    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the fan and generator V belt on the vane pump.

  1. While turning the belt tensioner counterclockwise, remove the bar.



5. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 5 bolts and 3 screws.

    Torque:
    for bolt:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }
    for screw:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).