CRANKSHAFT POSITION SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 5 bolts, 3 screws and engine under cover.
| 3. REMOVE FAN AND GENERATOR V BELT |
![]() |
While releasing the belt tension by turning the belt tensioner counterclockwise, remove the fan and generator V belt from the belt tensioner.
| 4. REMOVE GENERATOR ASSEMBLY |
![]() |
Remove the nut and disconnect the wire harness clamp bracket.
![]() |
Disconnect the generator connector.
Remove the terminal cap.
Remove the nut and disconnect the generator wire.
Remove the wire harness clamp.
Remove the bolt and disconnect the wire harness clamp bracket.
![]() |
Remove the 2 bolts and generator.
| 5. DISCONNECT COOLER COMPRESSOR ASSEMBLY |
![]() |
Remove the 2 nuts, 2 bolts and disconnect the cooler compressor.
| 6. REMOVE CRANKSHAFT POSITION SENSOR |
![]() |
Disconnect the sensor connector.
Remove the bolt and sensor.