Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY
  1. Remove the engine (Click here).



2. REMOVE CYLINDER HEAD SUB-ASSEMBLY RH (for Bank 1)
  1. Remove the cylinder head RH (Click here).



3. REMOVE NO. 1 WATER OUTLET PIPE


    A191545
  1. Remove the 4 wire harness clamps.

  1. Remove the bolt, 2 nuts and water outlet pipe.



4. REMOVE KNOCK SENSOR


    A075662
  1. Disconnect the 2 sensor connectors.

  1. Remove the 2 bolts and 2 sensors.