Home › ENGINE ยท 2UZ-FE › EMISSION CONTROL › AIR SWITCHING VALVE (for Bank 1)

AIR SWITCHING VALVE (for Bank 1) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT FENDER APRON SEAL LH


    A159336
  1. Remove the 5 clips and fender apron seal.



3. REMOVE NO. 2 AIR HOSE


    A191535
  1. Disconnect the air switching valve connector.

  1. Disconnect the fuel hose clamp.



    A153516
  1. Remove the air hose.



4. REMOVE NO. 3 AIR TUBE


A153518
  1. Remove the 4 nuts, air tube and 2 gaskets.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



5. REMOVE AIR SWITCHING VALVE ASSEMBLY


A191536E01
  1. Remove the 3 nuts and air switching valve.

    NOTICE:
    Do not hold the bracket of the air switching valve.