Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Standard cold tire inflation pressure:
    Tire size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P255/70R18
    210 (2.1, 30)
    230 (2.3, 33)
    P275/65R18
    P275/55R20
    P275/65R18*
    210 (2.1, 30)
    230 (2.3, 33)

    *: Vehicle with off road package



    R003031
  1. Using a dial indicator, check the tire runout.

    Tire runout:
    3.0 mm (0.118 in.) or less



2. ROTATE TIRE


C195151E01

HINT:
Rotate the tires as shown in the illustration.



3. INSPECT WHEEL BALANCE


    C080976E04
  1. Check and adjust the off-the-car balance.

  1. If necessary, check and adjust the on-the-car balance.

    Standard imbalance after adjustment:
    8 g (0.0180 lb) or less



4. INSPECT FRONT AXLE HUB
  1. Inspect the front axle hub (Click here).



5. INSPECT REAR AXLE SHAFT
  1. Inspect the rear axle shaft (Click here).